Weeder Module Support

Weedtech makes various types of I/O modules, they can be controlled by sending simple commands over the serial port. And they can be stacked together, so they only use one serial port. I use an Solid State Relay module (WT-SSR) to control my ITHO ECO fan. The SSR outputs are connected to the buttons on a RF remote module.

Create an ITHO Fan device and set the adress to the address of the SSR module ('A' in my case), then enter serial port for the Weeder module bus and Enabled it via the Setup Weeder Menu.

Resources

•  http://www.weedtech.com
•  http://www.itho.nl