Weeder Module Support

Weedtech makes various types of I/O modules, they can be controlled by sending simple commands over the serial port.
And they can be stacked together, so they only use one serial port.
I use an Solid State Relay module (WT-SSR) to control my ITHO ECO fan. The SSR outputs are connected to the buttons on a RF remote module.

Create an ITHO Fan device and set the adress to the address of the SSR module ('A' in my case), then enter serial port for the Weeder module bus and Enabled it via the Setup Weeder Menu.

Related Resources

    Updated by: rdnzl, Updated over 6 years ago
    Access count: 68694 since 2011-08-25

    wtdio-m.pdf (213 KB) rdnzl, 12/02/2008 11:51 AM

    wtssr-m.pdf (216 KB) rdnzl, 12/02/2008 11:51 AM

    weeder_itho.jpg (1.1 MB) rdnzl, 01/14/2009 08:08 PM

    wtssr-m.gif (22.9 KB) rdnzl, 08/23/2011 03:29 PM

    ihtorf.jpg (4.18 KB) rdnzl, 08/23/2011 03:29 PM

    Also available in: PDF HTML TXT